In 20 years of having to take
my car in to be serviced in
Utah County, this is the first time
someone happily offered to
give me a ride somewhere. I
was hooked on Honest-1 Auto 
Care from that moment!

-Mary A.

Starting and Charging Systems Service

How the Systems Work

The starting system includes a battery, starter motor, solenoid, ignition switch and in some cases a starter relay. An inhibitor (neutral safety switch) is included in the starting system to prevent the engine from being started if the vehicle is in gear.

When the ignition switch is turned to start position the battery provides current to the starter through the relay and solenoid. The starter engages a gear to a flywheel gear on the back of the engine and turns the engine over. The battery also supplies current to the ignition system which supplies spark to the plugs and ignites the fuel which causes the engine to start.

The Charging system includes an alternator (generator), drive belt, battery, voltage regulator and the associated wiring. After the engine is started and running, the alternator takes over as the source of power and the battery becomes part of the load on the charging system. The alternator supplies current back into the battery to keep the battery charged.

All the components are connected; a problem with one component can affect another component in the system. For example: an alternator that is defective and over charging can damage the battery.

Testing and Servicing

Honest-1® technicians are trained to test your vehicles battery, charging and starting systems to give you an accurate diagnosis for repair. The service provides a quick, accurate and comprehensive analysis of your vehicles critical electrical systems.

The Service Includes:
  • Inspecting the battery, cables, case and hold down bracket
  • Testing the surface charge and cold cranking amp capacity of your battery
  • Testing the voltage draw of your starter
  • Testing the voltage output of your alternator
  • Clean the battery terminals and connectors

  • Your starting system is ready to go when you are
  • Find a component problem before it can cause damage to another component saving you money
  • Improves reliability and performance